Chapter 6: Replacing Assemblies
To remove and replace the front panel assembly
Figure 6-9
Removing the BNC Nuts
Disconnect the Aux Out SMB cable W18 from J10 and the black Comp wire W19 from
4
J4. Push them to the side.
These cables are located behind the Aux Trigger Input BNC connector on the Acquisition board.
Figure 6-10
SMB Cable W18 and Comp Wire W19
Disconnect all the cables to the front panel assembly including the backlight cables,
5
flat-panel display driver cable W20, and keyboard cable W16.
6–10