Agilent Technologies 54835A Service Manual page 149

Figure 6-11
Disconnecting W16, W20, and the Backlight Cables
Remove the 4 Torx T15 screws that secure the chassis sides to the front panel assembly.
6
Figure 6-12
Front Panel Side Screws
Remove the 2 Torx T10 screws that secure the chassis front to the front panel assembly.
7
Pull the front panel assembly away from the chassis, being careful to feed the ribbon
8
cables W16 and W20 out through the slot in the front of the chassis.
To replace the front panel assembly, reverse the above procedure.
9
Ensure that you observe polarity designations when reconnecting the ribbon cables.
Chapter 6: Replacing Assemblies
To remove and replace the front panel assembly
6–11