Agilent Technologies 54835A Service Manual page 124

Chapter 5: Troubleshooting
To configure the motherboard jumpers and set up the BIOS
Re-enter the WINBIOS to change one parameter that could not be set in step 6.
7
a Press F1 to enter the BIOS Setup.
b Double-click on Detect IDE Utility. The line labeled "Pri. Master" should contain numeric
c Exit the BIOS Setup and save the changes you made.
Table 5-9 summarizes the settings for the system configuration.
Table 5-9 Series 757 System BIOS Settings with 120 Mbyte floppy drive
Configuration Item
Load Optimal Defaults
Standard Setup—Date/Time
Standard Setup—Floppy Drive A
Standard Setup—Floppy Drive B
Standard Setup—Pri Slave
Advanced Setup—System Keyboard
Advanced Setup—1st Boot Device
Advanced Setup—2nd Boot Device
PCI/PnP Setup—IRQ 9
Peripheral Setup (OnBoard Primary/Secondary IDE)
Power Management/APM
Hard Disk Power Down Mode
Hard Disk Time Out (minute)
Detect IDE Utility (Hard drive Primary Master)
The oscilloscope should now reboot, load Windows 95, and come up with the scope display. If it
does not, recheck your steps in the above procedure. If all the settings are correct, return to the
Primary Troubleshooting Procedure.
5–46
information indicating that it has found a hard drive. Exit this utility.
If a hard drive was not found, check Motherboard Hard Drive Cable W9 and SVGA to Hard
Drive Cable W10. If the drive is still not found, replace the hard disk drive.
Setting
YES
Enter current values
Not Installed
Not Installed
Floptical
Absent
Floptical
IDE-0
ISA
Primary
Enabled
Suspend
15 min
Data