Agilent Technologies 54835A Service Manual page 114

Chapter 5: Troubleshooting
To configure the motherboard jumpers and set up the BIOS
Table 5-7 Series 727 System Configuration Settings
Configuration Item
Load Optimal Defaults
Peripheral Setup (OnBoard Primary/Secondary IDE)
Detect IDE Utility (Hard drive Primary Master)
Standard Setup—Date/Time
Standard Setup—Floppy Drive A
Advanced Setup—System Keyboard
Advanced Setup—External Cache
Power Management/APM*
Hard Disk Power Down Mode*
Hard Disk Time Out (minute)*
* These configurations are only for instruments with 64 Mb or more of RAM.
Exit the Setup program, saving the changes you made.
7
The oscilloscope should now reboot and come up with the scope display. If it does not, recheck
your steps in the above procedure. If all the settings are correct, return to the Primary
Troubleshooting Procedure.
5–36
Setting
YES
Primary
Data
Enter current values
1.44 MB, 3-1/2
Absent
Disabled
Enabled
Suspend
15 min