Omron fq2 User Manual page 426

Menu command
When the com-
munications type
is RS-232C no-
protocol
Baud rate Set the baud rate to use for RS-232C
Data
length
Parity
Stop bit
Flow con-
trol
Delimiter
Interval
timeout
(text)
Interval
time-
out(after
Xoff
reception)
Communication
type
Area set-
tings(Only when
communications
type is PLC Link)
424
Menu Tables
Description
communications.
Sets the data length.
Sets the parity.
Sets the number of stop bits.
Sets the controls for the flow of commu-
nications with the software.
Set the delimiter to add to the end of
commands and responses.
Timeout [s] Set the time in seconds to
generate a timeout error.
Timeout [s] Set the time in seconds to
generate a timeout error.
Sets the communications type to use for
EtherNet/IP or PLC Link outputs.
Sets the area to write command data to
the Sensor.
Control inputs, command codes, and
command parameters are written to this
area.
Set the first address of the command
area.
Setting range
2400, 4800, 9600, 19200, 38400, 57600,
or 115200 (default: 38400)
7bit or 8bit (default: 8bit)
None, Odd, Even (default: None)
1bit, 2bit (default: 1bit)
None, Xon/Xoff (default: None)
CR, LF, or CR+LF (default:CR)
1 to 120 s, 0: Not monitored.
(default: 0 s)
1 to 120 s, 0: Not monitored.
(default: 0 s)
Invalid (default), PLC link (SYSMAC)
PLC link (MELSEC), EtherNet/IP
PLC Link (SYSMAC CS/CJ/CP/One)
CIO Area (CIO) (default)
Work Area (WR)
Holding Bit Area (HR)
Auxiliary Bit Area (AR)
DM Area (DM)
EM Area (EM0 to EMC)
PLC Link (MELSEC QnU/Q/QnAS)
Data Register
File Register
Link Register
0 to 99,999 (default: 0)
Data Refer-
ence
System p. 394
System p. 394
System p. 394
System p. 394
System p. 394
System p. 394
System p. 394
System p. 394
System p. 327
p. 328
System
System
FQ2 User's Manual