Figure 32: Ip Filter Screen - Quasar CF-3211 User And Installation Manual

 Common Name – Indicate the name of the person or other entity that the certificate
identifies (often used to identify the website).
 Valid days (self-signed certificate only) – Enter the period in days (1 ~ 9999) to indicate
the valid period of certificate.
5. Click OK to save the Certificate Information after completion.
Note:
The self-signed certificate does not provide the same high level of security as a
Certificate Authorized (CA)-issued certificate.
7.3.2.3 IP Filter
The IP filter restricts access to the camera by denying/allowing specific IP addresses. Click the IP
filter tab under the category Security in the sidebar to display the following page.
Enable IP Filter
1. Check the box to enable the IP Filter function. Once enabled, the listed IP addresses (IPv4) are
allowed/denied access to the camera.
2. Select Allow or Deny from the drop-down menu.
3. Click the Apply button to determine the IP Filter behavior.
Add/Delete IP Address
1. Enter the IP address in the Filtered IP Addresses text box.
2. Click Add to add a new filtered address. The Filtered IP Addresses box shows the currently
configured IP addresses. Up to 256 IP address entries may be specified.
3. To remove an IP address from the list, select the IP address and then click Delete.

Figure 32: IP Filter Screen

Configuration and Operation
31