Figure 8: Cable Gland - Quasar CF-3211 User And Installation Manual

To mount the camera, follow one of these procedures:

For indoor installations without a housing:
a. On the ceiling/wall/flat surface, install a security camera wall mount bracket stand
that is sturdy enough to hold the camera in a fixed position for the field of view
required.
b. Screw the bracket/stand to the mounting socket on the bottom of the camera.
c. Connect the cables and wiring to the camera. See Figure 4: CF-3211/CF-4221 Camera
Input/Output Connections and Table 2.

For indoor/outdoor installations using a typical protective camera housing:
a. Thread the wires through any of the infrastructure and brackets (e.g. pole
bracket/corner bracket/etc.) as needed as well as through the wall bracket arm.
b. Bolt the wall bracket (arm) to the prepared surface.
c. Loosen the screws or unlatch the camera housing lid, open the housing and loosen
the plastic cable glands (cable fittings).
d. Thread the cables through the cable glands into the camera housing.
e. Attach the camera housing to the wall bracket (arm) using the provided screws and
wrench.
f. Remove the housing plate (base for camera) and using the provided camera mount
screw, thread the screw through the plate into the camera's bottom mounting
socket.
g. Put the camera mounted on the base plate back in the housing. (We will adjust
forward positioning when we adjust the lens.)
h. For housings with internal blowers and heaters, connect the wiring to the camera
housing terminals (power input) according to the manufacturer's instructions for
heaters (heater output) and fans (blower output) that the camera housing features.
Connect any ground (GND) to the camera housing ground connection.
i. Connect the cables and wiring to the camera. See Figure 4: CF-3211/CF-4221
Camera Input/Output Connections and Table 2.

Figure 8: Cable Gland

Installation
11