Connecting Wires To A Spring Clamp Terminal Block - Quasar CF-3211 User And Installation Manual

Quasar CF-3211/CF-4221 User and Installation Guide
A.8. Connecting Wires to a Spring Clamp Terminal Block
The unit is delivered with a 7-terminal I/O block and a 3-terminal power connection block. The
terminal blocks enable you to connect wires to the unit.
To connect a wire to the spring clamp terminal block:
1. Strip the insulation from the end of each wire that is to be connected to the terminal
block. Approximately 1 cm (2.54") of wire should be exposed.
2. With a small screwdriver, press in and hold the orange spring clamp button next to the
female outlet where the wire will be inserted.
3. Insert the stripped end of the wire into the female outlet.
4. Release the orange spring clamp button.
112
Figure 100: Typical Spring Clamp Terminal Block
Figure 101: Connecting a Wire to a Terminal Block