Device Search Software; Initial Camera Configuration - Quasar CF-3211 User And Installation Manual

Quasar CF-3211/CF-4221 User and Installation Guide
A.2. Device Search Software
A.2.1 Initial Camera Configuration
To perform the initial camera configuration:
1. Unpack the camera. Rotate and remove the protective cover.
2. Remove the PE cloth sheet and lens cap. Attach the dome cover to the body.
3. Insert the RJ45 plug at the end of the network cable into the network port of the camera.
4. Do one of the following:

Copy and run the devicesearch.exe from the included CD.

From the Latitude Sidebar, run the Unified Configurator by selecting Applications >
Device Configuration Tool and then on the Unified Configurator screen, click DVTEL
HD Series.
5. In the Device Search application, click Device Search and do the following:
a. In the search results, click on the camera to select it.
b. Right-click and select from the shortcut menu Network Setup.
c. In the dialog that appears, select Static IP.
d. Enter the IP Address, Gateway and Netmask (network mask) as needed and click OK.
98
Note:
Device Search is an alternative software to DNA. Either of these programs
may be used. Both are supplied on the included CD.
Figure 90: Device Search Application