Initial Camera Configuration; Figure 5: Auto Iris Port Connection; Figure 6: Discovered Ip Devices - Quasar CF-3211 User And Installation Manual

4. If your lens has a DC auto iris, plug the auto-iris cable from the motorized lens
assembly into the AUTO IRIS port of the camera.
Tip:
If there are problems focusing, it might be necessary to make a back focus adjustment.

5.4 Initial Camera Configuration

To perform the initial camera configuration:
1. Unpack the camera and remove the protective cover.
2. Remove the PE cloth sheet and lens cap. Attach the dome cover to the body.
3. Connect one end of the Cat 5 Ethernet cable to the Ethernet port of the camera and the
RJ45 connector at other end to the Power Sourcing Equipment (PSE) device, such as a
switch.
4. Verify that the RJ45 connector LEDs illuminate green (indicating a stable network
connection) and flashing yellow (to indicate network activity).
5. Do one of the following:

Copy and run the dna.exe from the included CD.

From the Latitude Sidebar, run the Unified Configurator by selecting Applications >
Device Configuration Tool and then, on the Unified Configurator screen, click DVTEL
HD Series.
1. Mark the unit requiring IP assignment.

Figure 5: Auto Iris Port Connection

Note:
DNA is an enhanced software alternative to Device Search. Either of these
programs may be used. They are supplied on the included CD.

Figure 6: Discovered IP Devices

Installation
9