HP netserver e 800 Service Manual page 81

Chapter 6
Ensure the tabs at the front on the cage slide into the slots provided.
5. Connect the cables to the disk drive.
There are 2 connectors on each IDE cable. The primary cable is intended for the IDE CD-ROM
in the mass storage cage.
6. Connect the power cable to the drive.
The power cable is split into two cables, each with three power connectors. The designed
distribution is:
One string of three (PS-1 through PS-3): CD-ROM, optional tape drive, and shelf-mounted
hard disk drive.
Second string of three (PS-4 through PS-6): three cage-mounted hard disk drives.
If a power connector has no mate, for example, no optional tape drive installed, leave it
unconnected and use connector designed for the device you are connecting.
7. Replace the air duct and latch it into the chassis.
8. Replace the NetServer cover, external cables, and power cord.
9. Power up the NetServer as described in Chapter 1.
Slots for Tabs
Insert screws through
round holes in back,
first. (One each side.)
Installing the Mass Storage Cage
Replacing Parts
Tabs(2)
Captive
Screws (3)
75