HP netserver e 800 Service Manual page 40

Chapter 4
Code Description
0100 Keyboard error during POST
0101 Keyboard error
0102 Keyboard controller error
0103 Keyboard is not connected.
0105 Mouse boot error
0106 Mouse is not responding.
34
Problem/Solution
A key on the keyboard has been pressed during POST of the
HP NetServer.
To correct this:
1. Ensure nothing is placed on the keyboard and no key
is accidentally pressed down.
2. Reboot the NetServer.
3. If the error persists, your keyboard may need to be
replaced. Contact your service representative.
The keyboard has reported an error during its self-test.
To correct this:
1. Restart your HP NetServer.
2. If the error persists, your keyboard may need to be
replaced. Contact your service representative.
POST has detected a general failure in the integrated
keyboard controller.
To verify this error:
1. Restart your HP NetServer.
2. If the error persists, your system board may need to
be replaced. Contact your service representative.
POST has detected the keyboard is not connected.
To correct this:
1. Verify the keyboard connector is firmly connected.
2. Reboot the NetServer.
3. If the problem persists, your keyboard cable may be
damaged or your keyboard may need to be replaced.
Contact your service representative.
The system board has detected a mouse error during POST.
To correct this:
1. Clean the mouse and its moving ball as described in
the User's Guide.
2. If the problem persists, your mouse may need to be
replaced. Contact your service representative.
The system board has detected the mouse is not responding.
To correct this:
1. If the mouse has just been removed, press <Esc > to
Diagnostics