HP netserver e 800 Service Manual page 80

Chapter 6
3.Install the four screws to secure the drive to the mass storage cage.
CAUTION
a. Attach one of the screws through the round screw hole at the rear of the cage, then through
the elongated hole at the front of the cage.
b. Repeat on the other side of the cage.
4. Reinstall the mass storage cage.
74
4th
3rd
1st
Mass Storage Cage Screw Holes
All mounting screws used with the hard disk drive must be #6-32 and not exceed ¼-
inch in length. Longer screws may cause internal damage to the mass storage
device. Damage caused by incorrect mounting screws is not covered by the HP
warranty.
Tab
2nd
HDD3 (Shelf 6)
HDD4 (Shelf 7)
Tab
Replacing Parts