HP netserver e 800 Service Manual page 42

Chapter 4
Code Description
0301 Flexible disk drive B boot
error
(This does not apply to
E 800)
0305 Flexible Disk Drive Cable
conflict
(This does not apply to
E 800)
0306
Flexible disk drive controller
boot error
0307 Flexible disk drive controller
resource conflict
36
Problem/Solution
removed from the flexible disk drive.
2. Verify the flexible drive type configured in the Setup
utility matches the flexible disk drive installed in the
HP NetServer.
3. Verify all data cables and power cables are firmly
connected.
4. If the problem persists, your flexible disk drive may
need to be replaced. Contact your service
representative.
POST has detected the flexible disk drive B reported an error
during its self-test.
1. Verify a diskette can be properly inserted and
removed from the flexible disk drive.
2. Verify the flexible drive type configured in the Setup
utility matches the flexible disk drive installed in the
HP NetServer.
3. Verify all data cables and power cables are firmly
connected.
4. If the problem persists, your flexible disk drive may
need to be replaced. Contact your service
representative.
The flexible disk drive A is connected to the connector
configured for flexible disk drive B.
1. Run Setup Utility by pressing <F2>. In the flexible
disk drive section, enable the A & B flexible disk
swap.
2. Alternatively, if the connector allows it, connect the
flexible disk drive to the other connector on the
flexible disk drive cable.
POST has detected a general failure on the integrated
flexible disk controller.
To verify this:
1. Restart your HP NetServer.
2. If the error persists, your system board may need to
be replaced. Contact your service representative.
POST has detected an address space or IRQ resources
conflict between the integrated flexible disk controller and an
accessory board.
To correct this:
1. If the integrated flexible disk controller is not needed,
Diagnostics