HP netserver e 800 Service Manual page 38

Chapter 4
Code Description
0010 BIOS problem
0011 Battery problem
0012 BIOS initialization problem
0020 ISA initialization problem
(This does not apply to
E 800)
0021 PCI Configuration conflict
32
Problem/Solution
The PC configuration has been lost, cleared, corrupted, or
has not been initialized. When the HP NetServer remains
unplugged for a long period of time, the battery will discharge
and not provide enough current to keep the CMOS memory
powered.
To correct this:
1. Verify the battery is properly inserted.
2. If necessary, replace the battery as described in your
user's guide.
3. Run the Setup Utility to re-configure your NetServer.
The NetServer BIOS is not responding due to a possible
battery discharge. If the HP NetServer was unplugged for a
long period of time, the battery will discharge and not provide
enough current to keep the system date and time current.
To correct this:
1. Verify the battery is properly inserted.
2. If necessary, replace the battery.
3. Set time and date using the Setup utility or from your
operating system.
The HP NetServer configuration has been cleared or has not
been initialized.
Run the Setup Utility to re-configure your system.
The ROM on the accessory board is bad or the board has a
conflict with a system board reserved resource (address,
DMA, or IRQ).
To correct this:
1. Change the resources used by the ISA accessory
boards.
2. Try to disable <free> resources used by system
board devices.
3. If the problem persists, the accessory board may be
defective. Contact the accessory board vendor.
A configuration problem has occurred with a PCI device. The
PCI device or accessory board doesn't match PC setup
settings or has conflicts with PC resources (reserved memory
space, IRQ or DMA channels).
To correct this:
1. Clear the PCI configuration with the CMOS status
switch. Refer to the User's guide for details.
2. If necessary, use the Setup Utility to manually
Diagnostics