HP netserver e 800 Service Manual page 44

Chapter 4
Code Description
0501 Hard Disk secondary
controller boot error
(This does not apply to
E 800)
051X Hard Driver boot Error
(Error codes #0510, #0511,
#0512, and #0513 apply to
IDE0, IDE 1, IDE 2, and IDE
3 respectively as described
in the Setup Utility).
(This does not apply to
E 800)
052X Hard Drive not responding
(Error codes #0520, #0521,
#0522, and #0523 apply to
HDD0, HDD1, HDD2, and
HDD3 respectively as
described in the Setup
Utility).
(This does not apply to
E 800)
38
Problem/Solution
the secondary controller. Verify the secondary IDE
controller is enabled in Setup.
2. If the IDE device operates with the secondary
channel, your system board may need to be replaced
to recover primary channel functionality. Contact your
service representative.
3. If the device does not operate on either channel, the
IDE device may be defective. Contact your service
representative.
POST has detected a general failure on the integrated
secondary hard disk controller.
1. If no device uses the other IDE channel, connect
your hard disk drive to the other cable to operate with
the primary controller. Verify the primary IDE
controller is enabled in Setup.
2. If the IDE device operates with the primary channel,
your system board may need to be replaced to
recover secondary channel functionality. Contact
your service representative.
3. If the device does not operate on either channel, the
IDE device may be defective. Contact your service
representative.
POST has detected the specified hard disk drive reported an
error during its self-test.
To correct this:
1. Check the hard disk drive configuration with the
Setup Utility.
2. If necessary, edit the user hard disk parameters to
set lower values.
3. If the problem persists, your drive may need to be
replaced. Contact your service representative.
POST has detected the specified hard disk drive is not
responding, but is configured in the Setup utility.
To correct this:
1. If the specified hard disk has just been removed,
press <F4> to automatically validate the change.
2. Verify all data cables and power cables are firmly
connected.
3. If the cable is damaged, connect the hard disk drive
to another IDE cable, if available.
Diagnostics