Configuring Ntp Broadcast Mode With Authentication Example - HP 5820X Switch Configuration Manual

Perform the following configuration on Switch A:
# Enable NTP authentication.
[SwitchA] ntp-service authentication enable
# Set an authentication key.
[SwitchA] ntp-service authentication-keyid 42 authentication-mode md5 aNiceKey
# Specify the key as a trusted key.
[SwitchA] ntp-service reliable authentication-keyid 42
# View the NTP status of Switch B after clock synchronization.
[SwitchB] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 1.0.1.11
Nominal frequency: 64.0000 Hz
Actual frequency: 64.0000 Hz
Clock precision: 2^7
Clock offset: 0.0000 ms
Root delay: 31.00 ms
Root dispersion: 1.05 ms
Peer dispersion: 7.81 ms
Reference time: 14:53:27.371 UTC Sep 19 2005 (C6D94F67.5EF9DB22)
The output shows that Switch B has been synchronized to Switch A, and the clock stratum level of Switch B
is 3, while that of Switch A is 2.
# View the NTP session information of Switch B, which shows that an association has been set up Switch
B and Switch A.
[SwitchB] display ntp-service sessions
source
**************************************************************************
[12345] 1.0.1.11
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations :
Total associations :

Configuring NTP broadcast mode with authentication example

Network requirements
As shown in
segments and synchronizes the time among multiple devices.
Switch C's local clock is to be used as a reference source, with the stratum level of 3.
•
Switch C works in broadcast server mode and sends out broadcast messages from VLAN-interface 2.
•
Switch D works in broadcast client mode and receives broadcast messages through VLAN-interface
•
2.
• NTP authentication is enabled on both Switch C and Switch D.
reference stra
127.127.1.0
1
1
Figure 30, Switch C functions as the NTP server for multiple devices on different network
reach poll now
2 63 64 3
76
offset delay disper
-75.5 31.0 16.5