Configuring Netstream Aggregation Data Export Example - HP 5820X Switch Configuration Manual

[SwitchA] interface vlan-interface 2000
[SwitchA-Vlan-interface2000] ip address 12.110.2.1 255.255.0.0
[SwitchA-Vlan-interface2000] quit
[SwitchA] ip netstream export source interface vlan 2000
# Configure the destination host for the NetStream data export with the IP address being 12.1 10.2.2 and
port number being 5000.
[SwitchA] ip netstream export host 12.110.2.2 5000

Configuring NetStream aggregation data export example

Network requirements
As shown in Figure
• Switch A exports NetStream traditional data in version 5 export format to port 5000 of the
NetStream server at 4.1.1.1/16.
Switch A performs NetStream aggregation in the modes of protocol-port, source-prefix, destination-
•
prefix and prefix. Then aggregation data are sent in version 8 export format to the destination host
at 4.1.1.1, with port 3000, 4000, 6000, and 7000 for different modes.
NOTE:
All routers in the network are running EBGP. For more information about BGP, see
Configuration Guide
Figure 76 Network diagram for configuring NetStream aggregation data export
Configuration procedure
# Enable NetStream in both inbound and outbound directions of GigabitEthernet 1/0/1.
<SwitchA> system-view
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] ip netstream inbound
[SwitchA-GigabitEthernet1/0/1] ip netstream outbound
[SwitchA-GigabitEthernet1/0/1] quit
# In system view, configure the destination host for the NetStream common data export with the IP
address being 4.1.1.1 and port number being 5000.
[SwitchA] ip netstream export host 4.1.1.1 5000
76, configure NetStream on Switch A so that:
.
209
Layer 3—IP Routing