To do...
5.
Confirm the current topology
and save it as the standard
topology.
6.
Save the standard topology to
the FTP server or the local
Flash.
7.
Restore the standard topology
information.
Configuring interaction for a cluster
After establishing a cluster, configure FTP/TFTP server, NM host and log host for the cluster on the
management device.
After you configure an FTP/TFTP server for a cluster, the members in the cluster access the FTP/TFTP
•
server configured through the management device.
After you configure a log host for a cluster, all log information of the members in the cluster will be
•
output to the configured log host in the following way: first, the member devices send their log
information to the management device, which then converts the addresses of log information and
sends them to the log host.
After you configure an NM host for a cluster, the member devices in the cluster send their Trap
•
messages to the shared SNMP NM host through the management device.
If the port of an access NM device—including FTP/TFTP server, NM host and log host—does not allow
the packets from the management VLAN to pass, the NM device cannot manage the devices in a cluster
through the management device. You must configure the VLAN interface of the access NM device—
including FTP/TFTP server, NM host and log host—as the NM interface on the management device.
To configure the interaction for a cluster:
To do...
1.
Enter system view.
2.
Enter cluster view.
3.
Configure the FTP server
shared by the cluster.
4.
Configure the TFTP server
shared by the cluster.
5.
Configure the log host shared
by the member devices in the
cluster.
6.
Configure the SNMP NM host
shared by the cluster.
Use the command...
topology accept { all [ save-to
{ ftp-server | local-flash } ] | mac-
address mac-address | member-id
member-number }
topology save-to { ftp-server |
local-flash }
topology restore-from { ftp-server
| local-flash }
Use the command...
system-view
cluster
ftp-server ip-address [ user-name
username password { simple |
cipher } password ]
tftp-server ip-address
logging-host ip-address
snmp-host ip-address
[ community-string read string1
write string2 ]
156
Remarks
Optional
Optional
Optional
Remarks
—
—
Required.
By default, no FTP server is
configured for a cluster.
Required.
By default, no TFTP server is
configured for a cluster.
Required.
By default, no log host is
configured for a cluster.
Required.
By default, no SNMP host is
configured.