HP 5820X Switch Configuration Manual page 187

To do...
4. Configure the reflector port
for the remote source
mirroring group.
5. Create the remote probe
VLAN and enter VLAN view.
6. Assign monitor ports to
the remote probe VLAN.
7. Return to system view.
Configure the remote
8.
probe VLAN for the
remote source mirroring
group.
NOTE:
The reflector port of a remote source mirroring group must be an access port and belong to the
•
default VLAN, VLAN 1.
HP recommends you configure an unused port as the reflector port of a remote source mirroring
•
group and disable STP on it.
A mirroring group can contain multiple mirroring ports.
•
To make sure that the port mirroring function works properly, do not assign a mirroring port to the
•
remote probe VLAN.
• If you have already configured a reflector port for a remote source mirroring group, you can no
longer configure an egress port for it.
A VLAN can only serve as the remote probe VLAN for one remote source mirroring group. HP
•
recommends you use the remote probe VLAN for port mirroring exclusively.
A remote probe VLAN must be a static VLAN.
•
To remove the VLAN configured as a remote probe VLAN, you must remove the remote probe VLAN
•
with undo mirroring-group remote-probe vlan command first.
• If the remote probe VLAN of a remote mirroring group is removed, the remote mirroring group will
become invalid.
The link type of monitor ports configured for port mirroring must be access.
•
Use the command
mirroring-group group-id reflector-port
reflector-port
vlan vlan-id
port interface-list
quit
mirroring-group group-id remote-probe vlan
rprobe-vlan-id
177
Remarks
Required.
By default, no reflector port is
configured for a mirroring
group.
Required.
By default, no remote probe
VLAN is configured for a
mirroring group.
Required.
By default, a newly-created
VLAN does not have any
member port.
—
Required.
By default, no remote probe
VLAN is configured for a
mirroring group.