Configuring Dlsw Tests - HP 5820X Switch Configuration Manual

To do...
10. Configure the size of the data
field in each probe packet.
11. Configure the string to be
filled in the data field of each
probe packet.
12. Configure the number of
probe packets to be sent
during each voice probe
operation.
13. Configure the interval for
sending probe packets during
each voice probe operation.
14. Configure the interval the
NQA client must wait for a
response from the server
before it regards the response
times out.
15. Configure optional
parameters.
NOTE:
Only one probe operation is performed in one voice test.

Configuring DLSw tests

DLSw tests of an NQA test group are used to test the response time of a DLSw device.
Configuration prerequisites
Before you start DLSw tests, enable the DLSw function on the peer device.
Configuring a DLSw test
To configure DLSw tests:
To do...
1. Enter system view.
2. Enter NQA test group view.
3. Configure the test type as
DLSw and enter test type view.
Use the command...
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval packet-
interval
probe packet-timeout packet-
timeout
See "Configuring optional
parameters for an NQA test
group"
Use the command...
system-view
nqa entry admin-name operation-
tag
type dlsw
26
Remarks
Optional.
By default, the probe packet size
depends on the codec type. The
default packet size is 172 bytes
for G.711A-law and G.711 μ-law
codec type, and is 32 bytes for
G.729 A-law codec type.
Optional
By default, the string is the
hexadecimal number
00010203040506070809.
Optional.
1000 by default.
Optional.
20 milliseconds by default.
Optional.
5000 milliseconds by default.
Optional.
Remarks
—
—
Required.