Wps - ZyXEL Communications NBG6716 User Manual

The following table describes the general wireless LAN labels in this screen.
Table 16 Wireless Security
LABEL
Wireless Radio
Wireless
Network Name
(SSID)
Security mode
Wireless
password
Verify password
Apply
Cancel

WPS

5.6.6 WPS
Use this screen to add a wireless station to the network using WPS. Click WPS in the Wireless
Security to open the following screen.
Figure 30 Wireless Security: WPS
Chapter 5 Easy Mode
DESCRIPTION
Choose whether you want to apply the wireless security to 2.4G Hz or 5G Hz wireless
radio.
(Service Set IDentity) The SSID identifies the Service Set with which a wireless station is
associated. Wireless stations associating to the access point (AP) must have the same
SSID. Enter a descriptive name (up to 32 keyboard characters) for the wireless LAN.
Select WPA2-PSK to add security on this wireless network. The wireless clients which
want to associate to this network must have same wireless security settings as this device.
After you select to use a security, additional options appears in this screen.
Select No Security to allow any client to connect to this network without authentication.
This field appears when you choose wither WPA2-PSK as the security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Type the password again to confirm.
Click Apply to save your changes back to the NBG6716.
Click Cancel to close this screen.
Click this to configure the WPS screen.
You can transfer the wireless settings configured here (Wireless Security screen) to
another wireless device that supports WPS.
NBG6716 User's Guide
39