Leds - ZyXEL Communications NBG6716 User Manual

Make sure the power LED is on (not blinking).
1
Press the WPS button for more than three seconds and release it. Press the WPS button on another
2
WPS-enabled device within range of the NBG6716.
Note: You must activate WPS in the NBG6716 and in another wireless device within two
minutes of each other.
For more information on using WPS, see

1.7 LEDs

Look at the LED lights on the front panel to determine the status of the NBG6716. Use the LED
button at the side panel of the device to turn the LED lights on or off. If you have already pushed
the LED button to the ON position but none of the LEDS are on, make sure the NBG6716 is
receiving power and the power is turned on.
Note: The Power LED will be on even if you push the LED button to the OFF position.
This is for you to determine whether the NBG6716 is powered on.
Figure 3 LED Button
LED button
Chapter 1 Introduction
Section 8.2 on page
NBG6716 User's Guide
15
56.