Wall Mounting - ZyXEL Communications NBG6716 User Manual

1.8 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.
Table 2 Wall Mounting Information
Distance between holes
M4 Screws
Screw anchors (optional)
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
3
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the NBG6716 with the
4
connection cables.
Align the holes on the back of the NBG6716 with the screws on the wall. Hang the NBG6716 on the
5
screws.
Figure 5 Wall Mounting Example
Chapter 1 Introduction
12.7 cm
Two
Two
NBG6716 User's Guide
17