ZyXEL Communications NBG6716 User Manual page 173

Table 73 Maintenance > Sys OP Mode (continued)
LABEL
Access Point Mode
Apply
Cancel
Note: If you select the incorrect system operation Mode you may not be able to connect
to the Internet.
Chapter 23 Maintenance
DESCRIPTION
Select Access Point Mode if your device bridges traffic between clients on the
same network.
• In Access Point Mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port
labeled WAN. There is no WAN port.
• The DHCP server on your device is disabled.
• Router functions (such as NAT, bandwidth management, remote management,
firewall and so on) are not available when the NBG6716 is in Access Point
Mode.
• The IP address of the device on the local network is set to 192.168.1.2.
Click Apply to save your settings.
Click Cancel to return your settings to the default (Router).
NBG6716 User's Guide
173