How To Show A User Chart On The Radar Screen; How To Select User Chart To Use In Planning Mode - Furuno FEA-2807 Operator's Manual

15.5

How to Show a User Chart on the Radar Screen

If ECDIS workstation is set as SINGLE mode, you have to define on Radar Selection dialog box if the ECDIS sends
Route, User Chart and Notes to radar. When Route, User Chart or Notes is selected to Monitor mode, information
of Route, User Chart and Notes are sent to radar if "Send to Radar" is set "ON".
To change "Send to Radar" to ON or OFF, do the following:
1. Put the cursor on Radar in the status bar to show the Radar selections dialog box.
2. Put the cursor on ON (OFF) text in the "Send to Radar" field.
3. Spin the scrollwheel to select ON or OFF then push the scrollwheel.
15.6 How to Select User Chart to use in Planning
Mode
To activate the planning mode and select a user chart for the planning mode, do as shown in the illustration below.
15. User Chart Control
(WT)
User Chart
X
Monitor
DISP
Plan
DISP
Put cursor here and
roll scrollwheel to
select User Chart
in Planning Mode
15-7