Quick Start - Panasonic NV-GS85GC Operating Instructions Manual

LSQT1123_ENG.book 75 ページ ２００６年１２月２５日 月曜日 午前９時４５分
≥The viewfinder will be activated. (If the LCD
monitor is opened, the viewfinder will be
deactivated.)
ª
Adjusting the field of view
1
Adjust the focus by sliding the eyepiece
corrector knob.
12:30:45 12:30:45 12:30:45
15.10. 2007 15.10. 2007 15.10. 2007
12:30:45
15.10. 2007
≥You can adjust the brightness of the viewfinder
from the menu.

Quick start

When quick start is on the battery power is still
being consumed, even when the LCD monitor
and the viewfinder are closed.
The camera will resume recording/pause mode
about 1.7 seconds after the LCD monitor or the
viewfinder is reopened.
≥Please note in quick start mode approximately
half the pause recording power is being
consumed. Using quick start mode will reduce
the battery recording/playback time.
≥This is only activated in the following cases.
≥While using the battery
A tape or a card is inserted, while the Tape
Recording Mode is set.
A card is inserted, while the Card Recording
Mode is set.
≥While using the AC adaptor
Quick Start can be used even if a tape/card
is not inserted.
Before using
≥Set to Tape/Card Recording Mode.
1
Set [SETUP] >> [QUICK START] >> [ON].
( )
-80-
2
While the [OFF/ON] switch is still set to
[ON], close the LCD monitor and retract the
viewfinder.
≥The status indicator lights green and the unit
goes into quick start standby mode.
≥The movie camera will not go into quick start
standby mode unless the LCD monitor is
closed and the viewfinder is retracted.
3
Open the LCD monitor or extend the
viewfinder.
≥The status indicator lights red and the camera
is put into recording pause approx.
1.7 seconds after it is turned on.
ª
To cancel Quick Start
1
Set [SETUP] >> [QUICK START] >> [OFF].
( )
-80-
≥If the [OFF/ON] switch is set to [OFF] while the
unit is in quick start standby mode, the power
turns off.
≥If the standby continues for approx. 30 minutes,
then the status indicator will go off and the
camera will be completely turned off.
≥In the following cases, quick start is cancelled
and the power turns off.
≥When the Mode dial is moved.
≥When the battery or AC adaptor is removed.
≥When both the tape and card are removed
while using the battery in Tape Recording
Mode.
≥When the card is removed while using the
battery in Card Recording Mode.
≥When the movie camera is quick-started with
the white balance on automatic, it may take
some time until the white balance is adjusted if
the scene being recorded has a light source
different from the scene last recorded. (When
the colour night view function is used, however,
75
LSQT1123