Quick Start; Quick Power On - Panasonic HDC-SD100PC Operating Instructions Manual

High definition video camera
Hide thumbs Also See for HDC-SD100PC:
Table of Contents

Advertisement

Quick start

This unit will resume recording pause mode
about 0.6 seconds after the LCD monitor is
reopened.
≥ When in quick start standby mode about
60% of the power used in recording pause
mode is being consumed, so the recording
time will be reduced.
¬ Rotate the mode dial to select
1
Set the LCD/EVF select switch to
LCD. (l 35)
2
Select the menu. (l 29)
[SETUP] # [QUICK START] # [ON]
3
Close the LCD monitor while the
mode dial is set to
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
4
Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause approx. 0.6 seconds
after it is turned on.
≥ Set [QUICK START] to [OFF] to cancel the
quick start mode.
≥ Quick start standby mode is canceled if
jabout 5 minutes has elapsed
jmode dial is set to
junit is turned off
40
VQT1T64
≥ Time for quick start will be more than 0.6
≥ In the quick start mode, it may take some time
.
≥ In the quick start mode, the zoom
≥ If [POWER SAVE] (l 31) is set to
.

Quick power on

The unit is put into recording pause approx.
1.9 seconds when the mode dial is set to
from OFF.
≥ Start time will not shorten if there is no SD card
¬ Rotate the mode dial to select
Select the menu. (l 29)
[SETUP] # [QUICK POWER ON] # [ON]
≥ This function's default setting is [ON].
≥ Set [QUICK POWER ON] to [OFF] to cancel
≥ In the quick power on mode, the zoom
seconds slower in the following conditions.
jWhen 24p digital cinema is used
jWhen the unit is exposed to vibration or
shock
for automatic white balance to adjust, if the
scene being recorded has a light source
different from the scene last recorded. (When
the MagicPix function is used, however, the
white balance of the scene last recorded is
retained.)
magnification becomes 1k and the picture size
may differ from what it was before quick start
standby mode.
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
inserted.
the quick power on.
magnification becomes 1k and the picture size
may differ from what it was before turning
power off.
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hdc-sd100p

Table of Contents