Konica Minolta bizhub C352 User Manual page 328

Troubleshooting
Message
Please insert Fusing Unit
and close all doors.
Please install toner
cartridge, and close all
doors.
Please insert Waste
Toner Box and close all
doors.
Please insert Image
Transfer Belt Unit and
close all doors.
Replenish paper.
Toner cartridge (X) needs
to be replaced soon.
There is no Toner.
Stapler empty. Replace
Staple Cartridge or
cancel Staple mode.
Misfeed detected.
Reinsert the following #
of originals.
Malfunction detected.
Please call your
Technical
Representative.
Now Downloading
Program Data from
Firmware server.
C352
Cause
The fusing unit is not installed
correctly.
The indicated toner cartridge
is not installed correctly.
The waste-toner box is not
installed correctly.
The image transfer belt unit is
not installed correctly.
The indicated tray has run out
of paper.
The toner for the indicated
color is about to run out.
Since the toner for the
indicated color has run out,
the machine is unable to
make copies.
The staples have run out.
Since a paper misfeed
occurred, the machine is
unable to make copies.
After clearing a paper
misfeed, it is necessary to
reload certain pages of the
original that have already
been fed through the ADF.
The machine malfunctioned
and is unable to make copies.
ΠCS Remote Care was
activated by the technical
representative.
 Internet ISW is being
downloaded.
Remedy
Reinstall the consumables or parts,
or contact your technical
representative.
Load paper into the indicated tray.
(See "Loading paper into the tray 1"
on page 2-43, "Loading paper into
the tray 2, 3 or 4" on page 2-47,
"Loading paper into the LCT" on
page 2-49, and "Loading paper into
the bypass tray" on page 2-52.)
Prepare to replace the toner
cartridge according to your
maintenance agreement.
Replace the toner cartridge
according to your maintenance
agreement.
Replace the staple cartridge. See
"Replacing the staples" on
page 9-10.
Clear the paper misfeed. (See
"When the message "Misfeed de-
tected." appears" on page 5-5.)
Load the indicated original pages
into the ADF.
Inform your technical representative
of the code displayed on the touch
panel.
Do not turn off the machine with the
[Power] (sub power) key while this
message is displayed.
After turning off the machine with
the [Power] (sub power) key, turn off
the main power switch, and then
contact the technical
representative.
5
5-71