Finisher - Konica Minolta bizhub C352 User Manual

Troubleshooting

Finisher

Symptom
The finisher cannot be
used.
The pages cannot be
stapled.
The staple is incorrectly
positioned by 90º.
The pages that were fed
out were not uniformly
loaded and the punched
holes or staples are
incorrectly positioned.
Even though a Punch
setting was selected,
holes are not punched.
(when punch kit is
installed on finisher)
If any message other than those listed above appears, perform the operation
described in the message.
If the problem is not corrected after the described operation is performed,
contact your technical representative.
C352
Possible Cause
Is no power supplied to the
connector?
Have the staples run out?
Are the staples positioned as
specified?
Is the paper curled?
Is there a gap between the
lateral guides in the paper
tray and the side of the
paper?
Did the message "Remove
punch scraps." appear?
Remedy
Check that the cord is correctly
inserted into the connector.
Replace the staple cartridge. (See
p. 9-10.)
Select the desired position for the
staples. (See p. 3-75.)
Remove the paper from the paper
tray, turn it over, and then load it
again.
Slide the lateral guides in the paper
tray against the side of the paper so
that there is no gap.
Empty the hole-punch waste
container.
5
5-69