Corresponding Arm Adjustment; To The Back Angle - Invacare ORBIT Service Manual

BACK
CORRESPONDING ARM
ADJUSTMENT TO BACK ANGLE
(FIGURE 3)
NOTE: This adjustment is recommended if the back
angle has been changed to keep arm parallel to
the ground/floor.
B
1. Flip the cantilever arm up and out of the way.
A
2. Remove the locknut that secures the locking pin
C
to the adjustment plate. See FIGURE 3-
DETAIL "A".
K
Adjustment
Locking Pin
Back
Plate
Back
Plate
Back
Plate
FIGURE 3 - CORRESPONDING ARM ADJUSTMENT TO BACK ANGLE OF THE CANTILEVER ARM
DETAIL "A"
Plate
Locknut
Washer
O O O O O
80 80
80 80 80
Arm
Plate
O O O O O
85 85 85
85 85
Arm
Plate
O O O O O
90 90 90 90 90
Arm
Plate
3. Refer to FIGURE 3 to determine the mounting
hole in the adjustment plate that will be used to
correspond to the back angle.
NOTE: Back angles of 105
same arm adjustment plate mounting holes.
4. Securely tighten the locking pin and washer to
the adjustment plate with a locknut.
5. Repeat STEPS 1-4 for the opposite side, if nec-
essary.
Back
Plate
Back
Plate
105 105 105 105 105
Back
Plate
13
PROCEDURE 3
o o
and 110 will use the
O O O O O
95 95
95 95 95
Arm
Plate
O O O O O
100 100 100 100 100
Arm
Plate
O O O O O O O O O O
AND 110 AND 110 AND 110 AND 110 AND 110
Arm
Plate
B
A
C
K