Invacare ORBIT Service Manual page 44

PROCEDURE 5
Reassembly of the Non-Tilt-in-Space
Orbit (FIGURE 2)
C
H
1. Reinstall the seat plate assembly into the base
A
frame with the mounting screws and locknuts at
N
height noted in DISASSEMBLY OF THE BASE
G
FRAME - NON-TILT-IN-SPACE ORBIT. Se-
I
curely tighten.
N
G
T The non-tilt rods and the seat plate assembly
H
MUST be adjusted to the exact same mount-
E
ing position (i.e. - HIGH - HIGH; MIDDLE -
MIDDLE; or LOW - LOW). The seat plate assem-
W
bly MUST remain level - otherwise, injury may
I
result.
D
T
2. Secure the lower portion of the non-tilt rods to
H
the mounting brackets with the mounting screws
and locknuts. Securely tighten.
Seat Plate
Assembly
LOW
position
MIDDLE
position
HIGH
position
Base Frame
Mounting
Screw
(STEP2)
FIGURE 1 - ADJUSTING THE SEAT HEIGHT - NON-TILT-IN-SPACE ORBIT
WARNING
Locknut
(STEP2)
Mounting
Screw
(STEP 2)
3. If so equipped, install the NEW crossmember of
the foot activated wheel lock. Refer to CHANG-
ING THE WIDTH OF THE FOOT ACTIVATED
WHEEL LOCKS in this PROCEDURE of the
manual.
4. Install the rear wheels. Refer to REMOVING/
INSTALLING THE REAR WHEELS in PROCE-
DURE 8 of the owner's manual, part number
1073955.
5. Adjust wheel locks. Refer to WHEEL LOCK
ADJUSTMENT in PROCEDURE 8 of the
owner's manual, part number 1073955.
6. Install the seat frame to the base frame. Refer
to DISASSEMBLY in PROCEDURE 2 of this
manual.
NOTE: If the wheelchair has become less stable af-
ter changing the width, reposition the rear wheels.
Refer to ADJUSTING THE WHEELBASE LENGTH
in PROCEDURE 7 of this manual.
Seat Plate
Non-Tilt Rods
Locknut
(STEP 2)
44
CHANGING THE WIDTH
Mounting
Screw
(STEP 2)
Mounting
Screw
(STEP 2)
LOW position
MIDDLE position
HIGH position
Non-Tilt Rods
(STEP 2)