Replacing Armrest Arm Pad; Removing/Installing Hand Grips - Invacare Action 5 Service Manual

Hide thumbs Also See for Action 5:

Table of Contents

Replacing Armrest Arm pad

NOTE: For this procedure, refer to FIGURE 3.3.

1. Remove the mounting screws (M5) that secure the arm pad to the armrest assembly.

2. Replace arm pad and securely tighten with the existing mounting screws (M5).

3. Repeat STEPS 1

After ANY adjustments, repair or service and BEFORE use, make sure all attaching

hardware/components are fitted securely - otherwise injury or damage may occur.

1. Remove end caps from backrest canes, if present.

2. Remove the hand grips from the back canes (Cut the handle lengthwise thanks to a

sharp tool).

3. Install new end caps on backrest canes, if necessary.

4. Install the new hand grips on the back canes (Previously, spray a solution of neutral

alcohol inside the handle and settle it immediately on the back cane).

5. Ensure hand grips are settled to the desired position on each side.

NOTE: Both hand grips should be set at the same position.

2 for the opposite side if necessary.

Mounting

screws (M5)

FIGURE 3.3 Replacing Armrest Arm Pad

W A R N I N G

Arm pad

Armrest

assembly

1 3

SECTION 3—ARMRESTS

Table of Contents

Myon hc