System >Trace Route; System > Mac Notification Settings - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
Figure 4.36 – System > Ping Test
The user may tick the Infinite times radio button to tell the ping program to keep sending ICMP Echo packets
to the specified IP address until the program is stopped. You may opt to choose a specific number of times to
ping the Target IPv4 or IPv6 Address by clicking its radio button and entering a number between 1 and 255.
Click Start to initiate the Ping test.
Target IP Address: Enter an IPv4 or IPv6 address to be pinged.
Repeat Pinging for: Enter the number of times desired to attempt to Ping either the IPv4 or the IPv6
address configured in this window. Enter a number of times between 1 and 255.
Timeout: For IPv4, select a timeout period between 1 and 99 seconds for this Ping message to reach its
destination. For IPv6, select a timeout period between 1 and 10 seconds for this Ping message to reach its
destination. In either case, if the packet fails to find the IP address in this specified time, the Ping packet will
be dropped.
System >Trace Route
From this page you can trace a route between the switch and a given host on the network.
Figure 4.37 – System > Trace Route
IP Address: Enter an IPv4 or IPv6 address of the destination station.
TTL (1-60): The time to live value of the trace route request. This is the maximum number of routers that a
trace route packet can pass. The trace route option will cross while seeking the network path between two
devices. The range for the TTL is 1 to 60 hops.
Port (30000-64900): Enter a port number. The value range is from 30000 to 64900.
Timeout (1-65535): Defines the timeout period while waiting for a response from the remote device. A value
of 1 to 65535 seconds can be specified. The default is 3 seconds.
Probe (1-9): Enter a number for probing. The range is from 1 to 9. If unspecified, the default value is 3.
System > MAC Notification Settings
The MAC Notification page is used to monitor MAC addresses learned and entered into the forwarding
database. To globally set MAC notification on the Switch, select enabled or disabled, input the time interval
between notification and history size, then click the Apply button.
3 3 0 0