Configuration > Mld Snooping > Mld Host Table; Configuration > Ism Vlan Settings - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
Max Response Time (10-25 sec): Specifies the time interval in seconds after which a port is removed from
the Multicast membership group. Ports are removed from the Multicast membership when the port sends a
Done Message, indicating the port requests to leave the Multicast group. The field range is 10-25 seconds.
The default timeout is 10 seconds.
Click Apply to implement changes made.
Click the Edit button to enter the Router Port Settings page, and the ports to be assigned as router ports for
MLD snooping for the VLAN.
A router port configured manually is a Static Router Port and a Dynamic Router Port is dynamically
configured by the Switch when a query control message is received. Press Apply for changes to take effect.
Figure 4.60 – Configuration > MLD Snooping > MLD Snooping-Router Port Settings
To view the Multicast Entry Table for a given VLAN, press the View button.
Figure 4.61– Configuration > MLD Snooping > MLD Snooping-Multicast Entry Table
Configuration > MLD Snooping > MLD Host Table
The MLD Host Table page displays the MLD Snooping information.
Figure 4.62 - Configuration > MLD Snooping > MLD Host Table
Configuration > ISM VLAN Settings
In a switching environment, multiple VLANs may exist. Every time a multicast query passes through the
Switch, the switch must forward separate different copies of the data to each VLAN on the system, which, in
turn, increases data traffic and may clog up the traffic path. To lighten the traffic load, multicast VLANs may
be incorporated. These multicast VLANs will allow the Switch to forward this multicast traffic as one copy to
recipients of the multicast VLAN, instead of multiple copies.
Regardless of other normal VLANs that are incorporated on the Switch, users may add any ports to the
multicast VLAN where they wish multicast traffic to be sent. Users are to set up a source port, where the
multicast traffic is entering the switch, and then set the ports where the incoming multicast traffic is to be sent.
The source port cannot be a recipient port and if configured to do so, will cause error messages to be
produced by the switch. Once properly configured, the stream of multicast data will be relayed to the receiver
ports in a much more timely and reliable fashion.
The ISM VLAN Settings page allows the user to configure the ISM VLAN.
4 4 0 0