Security > Access Authentication Control > Authentication Server - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
Figure 4.103 – Security > Access Authentication control > Authentication Server Group
Enter a group name of no more than 15 alphanumeric characters to define the user group. After clicking
Apply, the new user-defined group will be displayed in the Server Group table. Here, it can be configured
as the user desires.
The Switch has two built-in Authentication Server Groups that cannot be removed but can be modified. To
modify a particular group, click Edit button and the following window will appear.
Figure 4.104 – Security > Access Authentication control > Authentication Server Group-Edit
Select Group Name, Protocol and IP address then click Add to implement the changes.
Security > Access Authentication Control > Authentication Server
From this page you can set user-defined Authentication Server Hosts for the RADIUS security protocols
on the Switch. When a user attempts to access the Switch with Authentication Policy enabled, the Switch will
send authentication packets to a remote RADIUS server host on a remote host. The RADIUS server host will
then verify or deny the request and return the appropriate message to the Switch. The maximum supported
number of server hosts is 16.
To add an Authentication Server Host:
IP Address: Select IPv4 or IPv6 and then enter the server IP address.
Protocol: The protocol used by the server host. Select from one of the following:
NOTE: You must configure Authentication Server
Hosts using the Authentication Server Hosts page
before adding hosts to the list. Authentication
Server Hosts must be configured for their specific
protocol on a remote centralized server before this
function can work properly.
Figure 4.105 – Security > Access Authentication control > Authentication Server
6 6 4 4