How To Set Up - Britax TRUFIX Instructions For Installation & Use

HOW TO SETUP
INSTALL INTO VEHICLE
Remove all packaging from the child restraint. Remove
the ISOFIT insertion guides (page 14, Ref 22) from the
supplied location and store safely for further use.
Before you install the child restraint in the vehicle,
please ensure that the shoulder straps are adjusted
to the correct height (refer to page 18). With the child
restraint on stable ground, place the child into the child
restraint and adjust the Hassle Free Harness™ backrest
to achieve correct fitment of the harness to the child's
shoulders (as shown 'A').
RECLINE RESTRAINT
A. Determine whether an upright or reclined position is
preferred and adjust as required (as shown 'B').
B. To recline, place one hand on the front corner of base
firmly, while with the other hand lift the recline latch up to
unlock, pulling forward until the restraint is at the desired
position. Ensure the recline latch is engaged into position
by pushing on the restraint.
The child restraint may be reclined without removing the child,
however:
A. The top tether strap will need to be adjusted to suit the
desired recline position.
B. When used with a seatbelt installation the seatbelt may
need to be adjusted to suit the desired recline position.
C. When used with ISOFIT installation. Ensure the
restraint is pushed back fully towards the seat back
(page 22, Ref I) after recline adjustment.
D. Ensure the slack is removed from the vehicle seatbelt
and/or the top tether before use.
16
Instructions for Installation & Use - Series No. 6100/A/2013
25mm
Slot below
shoulder.
A
B
Lift Recline Latch
FULLY UPRIGHT FULLY RECLINED
CHILD USE MODE CHILD USE MODE
ADJUSTING HASSLE FREE
HARNESS™ BACKREST
Correct fitment of the harness is very
important as it restrains the child in the
restraint. The harness must fit firmly
around the upper torso of the child and
be positioned so as to leave the child's
arms and legs free.
If the Backrest is in the top position and the
shoulders are above the upper shoulder
height marker then the child is too tall for
the restraint and the restraint should not be
used; move to next type of restraint (see
pages 7 to 12).
The shoulder straps must be in the slots which are
nearest to the child's shoulders, but not more than
25mm below the child's shoulders. There is only one
set of slots so the seat will always have the shoulder
straps in place once the headrest is positioned
correctly, just above the child's shoulders.
NOTE: This child restraint does not require the strap
to be disconnected to adjust their height, only the
backrest needs to be moved to adjust the shoulder
strap position.
Always adjust the height of the shoulder straps
as the child grows.
Instructions for Installation & Use - Series No. 6100/A/2013
HOW TO SETUP
Shoulder
Harness
Shoulder slots harness straps
Upper
shoulder
height
marker
Harness
Lower
tongues and
shoulder
buckle
height
marker Lap strap
slots
Harness
Crotch strap
adjuster
slots
lever
Harness
adjuster strap
25mm
Slot below
shoulder.
17