Britax TRUFIX Instructions For Installation & Use page 10

HOW TO SETUP
HOW TO ADJUST THE HASSLE FREE HARNESS™ BACKREST
A. Loosen the harness straps before adjusting the backrest.
B. To make adjustments you will need to remove the child and the restraint from the vehicle.
C. Slacken the harness shoulder straps.
D. To adjust the backrest, squeeze and tilt the latch on the back of the restraint and lift the cross bar up or
down to position the bottom of the backrest to be just above the child's shoulders. Release the latch to
lock the headrest in position. Pull backrest upwards to check it is locked in position. Ensure the cross
bar is latched correctly.
Squeeze and tilt the latch and lift up or down
18
Instructions for Installation & Use - Series No. 6100/A/2013
Latch
Cross bar
HOW TO INSTALL USING ISOFIT™
WHAT ARE ISOFIX LOW ANCHORAGES IN A VEHICLE?
ISOFIX low anchorages are fixed, standardised anchoring points for securely installing an ISOFIX
compatible child restraint in a vehicle with ISOFIX low anchorages.
It has now become an international standard for vehicles. This anchoring technology minimises installation
mistakes by optimising the protective effect of a solid connection between vehicle and ISOFIX compatible
child restraint.
HOW TO INSTALL USING THE VEHICLE'S ISOFIX LOW ANCHORAGES
After adjusting the shoulder belts (refer to page 16
and 17) fasten the child restraint to the ISOFIX low
anchorages as follows:
A: Locate the ISOFIX low anchorages in the vehicle
seat. The location may be identified by one of the
following symbols,
If you cannot locate them, check your vehicle owners
manual.
B. If necessary, clip the two insertion guides to the two
ISOFIX low anchorages of the vehicle seat (between
seat and backrest). The cutout must point upwards.
Push in and allow to rise to hook on to bars of the ISOFIX low anchorage. If the
bar can be seen or the vehicle seat has built in guides, the provided insertion
guides may be unsuitable.
To prevent damage to vehicle seat it may be necessary to remove or open a
trim covering the ISOFIX low anchorages.
NOTE: The insertion guides should be removed when not in use and kept in a safe place. In vehicles
with folding down backrests, the insertion guides must be removed before folding down the backrest.
Instructions for Installation & Use - Series No. 6100/A/2013
ISOFIX low anchors of the vehicle seat
B
Insertion guides
19