Table of Contents
Advertisement
Quick Links
TRUFIX™
HARNESSED CAR SEAT
ISOFIX COMPATIBLE
6 months to 4 years (approx.)
Instructions for Installation & Use
Series No. 6100/A/2013
6 months
to 4 years
(approx.)
COMPATIBLE
IMPORTANT:
KEEP THIS BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT
Instructions for Installation & Use - Series No. 6100/A/2013
Advertisement
Table of Contents
Related Manuals for Britax TRUFIX
Summary of Contents for Britax TRUFIX
- Page 1 TRUFIX™ HARNESSED CAR SEAT ISOFIX COMPATIBLE 6 months to 4 years (approx.) Instructions for Installation & Use Series No. 6100/A/2013 6 months to 4 years (approx.) COMPATIBLE IMPORTANT: KEEP THIS BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT Instructions for Installation & Use - Series No. 6100/A/2013...
- Page 2 ISOFIT QUICK SETUP SEATBELT QUICK SETUP SEE PAGE 19 - 23 FOR FURTHER INFORMATION SEE PAGE 24 - 27 FOR FURTHER INFORMATION Instructions for Installation & Use - Series No. 6100/A/2013 Instructions for Installation & Use - Series No. 6100/A/2013...
- Page 3 INTRODUCTION INTRODUCTION To be used only in a forward-facing position by a child whose shoulders are above the lower shoulder Chỉ được sử dụng ở vị trí hướng mặt về phía trước cho em bé nào có vai trên vạch ghi độ cao của vai ở...
- Page 4 Carefully read all the instructions for installation in this book. If in doubt about the method of installation, consult Britax childcare or agent or a child restraint fitter or, in New Zealand, to consult the agent for the IN CASE OF CRASH vehicle.
- Page 5 IMPORTANT : • Fit the restraint firmly to the car seat. • Do not attach the lower attachment connectors of two separate child restraints to the same ISOFIX low • Fit the harness firmly to the child. anchorages in your car. •...
-
Page 6: Shoulder Height Markers Anda Growing Child
From approximately 6 months of age. remain in their previous child However, Britax recommends that you keep your restraint. Approximately 6 months child in a rearward facing restraint for as long as of age. -
Page 7: Special Features
SHOULDER HEIGHT MARKERS AND THE NEXT SEAT SPECIAL FEATURES Next type of restraint that can be used in the car for your child. When your child has outgrown the seat, you can then either use: • Convertible Booster Seat (Note: you can move to a convertible booster seat once the child's shoulders reach the lower shoulder height marker in the convertible booster seat), Convertible Booster seat used with... -
Page 8: Suitable For Use
FEATURES SUITABLE FOR USE 12. Car's Upper Anchorage fitting TO BE USED WITH A LAP SASH OR LAP ONLY SEATBELT OR ISOFIX LOW ANCHORAGES IN THE 13. Lower Connector Protection Moulding BACK OF MOST CARS WITH FORWARD-FACING SEATS. 14. Upper Lock-off (seatbelt path) Continue to use this child restraint until the child reaches this limit. -
Page 9: How To Set Up
HOW TO SETUP HOW TO SETUP INSTALL INTO VEHICLE ADJUSTING HASSLE FREE Shoulder Harness HARNESS™ BACKREST Shoulder slots harness straps Remove all packaging from the child restraint. Remove Upper 25mm the ISOFIT insertion guides (page 14, Ref 22) from the Correct fitment of the harness is very shoulder supplied location and store safely for further use. - Page 10 HOW TO SETUP HOW TO INSTALL USING ISOFIT™ HOW TO ADJUST THE HASSLE FREE HARNESS™ BACKREST WHAT ARE ISOFIX LOW ANCHORAGES IN A VEHICLE? ISOFIX low anchorages are fixed, standardised anchoring points for securely installing an ISOFIX A. Loosen the harness straps before adjusting the backrest. compatible child restraint in a vehicle with ISOFIX low anchorages.
- Page 11 HOW TO INSTALL USING ISOFIT™ HOW TO INSTALL USING ISOFIT™ C. Using the green handle, pull the connector assembly E. The hook must be open on both ISOFIT connectors. Open backwards as far as it will go. To open the hook squeeze the green locking button Green handle and the red release button together.
- Page 12 HOW TO INSTALL USING ISOFIT™ HOW TO INSTALL USING ISOFIT™ H. Push in the other side of the child restraint into the CAUTION: insertion guides and engage the ISOFIT connector CHILDREN CAN BE INJURED OR RESTRAINTS AND TOP TETHER STRAP DAMAGED BY ("click") on each side.
-
Page 13: How To Install Using Seatbelt
HOW TO INSTALL USING SEATBELT HOW TO INSTALL USING SEATBELT HOW TO INSTALL USING LAP SASH E. Push down on the restraint to compress it into the SEATBELT vehicle seat. Whilst compressed in the seat, pull on the lap portion to remove all slack from the After adjusting the shoulder belts (refer to page 16 and 17) belt. - Page 14 HOW TO INSTALL USING SEATBELT HOW TO INSTALL USING SEATBELT FITTING SUMMARY H. Whilst still compressing the restraint in the seat pull the top tether adjustment strap (C) to remove any slack but do not tighten so much that the restraint lifts off the car seat. Top Tether Car's Anchor Fitting Always secure the loose end of the top...
-
Page 15: How To Use
Pull harness buckle up DANGEROUS. between child’s legs. Do not use restraint if straps do not tighten. Contact Britax or your local authorised service agent for repair. DO NOT LEAVE CHILDREN Pull to UNATTENDED IN THE CAR. -
Page 16: Care And Maintenance
HOW TO USE CARE & MAINTENANCE REGULAR CARE OF THIS RESTRAINT: TO REMOVE CHILD Press red button on harness buckle then both harness tongues will be released. Lift the shoulder straps Please check the following items regularly to ensure the safety of your child: from the child’s shoulders. - Page 17 Check the harness buckle is clean by engaging the harness tongues and buckle several times ONLY USE BRITAX SAFE-N-SOUND SEAT COVERS AND ACCESSORIES THAT ARE DESIGNED until you hear a click. AND TESTED FOR USE WITH THIS PRODUCT.
- Page 18 CARE & MAINTENANCE CARE & MAINTENANCE TO REMOVE COVER: F. Lift headrest up to highest position. Unclip the press studs on the cover in the middle panel. A. Remove the restraint from vehicle. B. Disengage the harness tongues from the harness G.
- Page 19 If an aftermarket stretch the cover over the shell while feeding accessory is used that is not recommended by Britax Safe-n-Sound then ensure that the accessory the crotch buckle, harness tongues through is compliant with AS/NZS 8005 and stated as suitable for use with this child restraint.
- Page 20 INSTALLATION OF CAR'S UPPER ACCESSORIES ANCHORAGE POINT MESSY MAT™ (IF SUPPLIED) Consult the vehicle owner’s handbook for location of anchorage fittings or anchorage points and the Long Messy Mat possible use of spacers. Some vehicles may have an anchor fitting fitted by the vehicle manufacturer. If (if supplied) The Messy Mats have been specifically designed to protect your anchorage points cannot be found refer to car manufacturer or local child restraint fitting station or traffic...
-
Page 21: Installation Of Car's Upper Anchorage Point
ANCHORAGE POINT Top tether extension Strap distance to be measured. IF THE CAR IS FITTED WITH CHILD RESTRAINT UPPER ANCHORAGE FITTING Length 300mm (Use Britax Safe-n-Sound part 0035). Fig.1. UPPER ANCHORAGE POINT Attachment Bolt Length 600mm (Use Britax Safe-n-Sound part 0036). - Page 22 Fig.3. seating position CAR INSTALLATION ACCESSORIES (From retailers of Britax Safe-n-Sound products) EXTRA ANCHOR KITS: Available for using the restraint in additional cars. Re-order no: 0038 TOP TETHER EXTENSION STRAPS: May be required for cars without a fixed parcel shelf.
-
Page 23: In Case Of Crash
Our Crash Exchange Terms and Application form are accessible on our website. Please visit NZS1754-2013 which requires us to advise users of child restraints to "Destroy the entire www.britax.com.au for further information. restraint if it has been in use in a severe crash, even if no damage is obvious". The joint Australian/New Zealand Standards committee CS/85, advise that this statement applies whether a child was in the child restraint or not. - Page 24 NOTES NOTES Manufactured to AS/NZS 1754: 2010 and 2013. THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE THE ANCHORAGE STRAP MAY FALL INTO THE SPLIT IN THE SEAT BACK (E.G. HATCHBACK OR STATION WAGON). The child should not sit forward facing until the child’s neck muscles are able to support their head. Children that have out grown this restraint are safest in their booster seat until their shoulders reach the upper shoulder height marker of the booster seat.
- Page 25 The BRITAX trademark is the property of Britax Childcare Holdings Ltd, UK. We reserve the right to alter this product without notice. © 2014 Britax Childcare Pty. Ltd. This product is covered by Australian and overseas patent applications. P/No. 2201475/B...