How To Set Up - Britax SICT Easy Adjust 7200/A/2010 Series Instructions For Use Manual

INSTALLING INTO VEHICLE REARWARD
FACING
A. The restraint is normally packaged in the fully upright
forward facing mode so if you need to use it rearward
facing you must first fully recline the restraint. Convert
the restraint to rearward facing mode by referring to
steps below.
B. If Upper Anchorage Strap is folded up for storage
undo Storage Strap then lengthen. Fully press Upper
Anchorage Adjuster Button (A) while pulling Upper
Anchorage Strap (B) to lengthen.
FULLY RECLINE IN CHILD USE MODE:
Place one hand on the front corner of the base firmly
while with the other hand lifts the Grey Recline Latch up
to unlock, continue pulling restraint forward until fully
reclined. The Blue Release Latch prevents over reclining
when installed forward facing.
CONVERT TO REARWARD FACING
MODE:
Once fully reclined, press the Blue Release Latch located
under the restraint body while with the other hand lifts
the Grey Recline Latch up to unlock, continue pulling the
restraint forward until fully reclined into rearward facing
mode.
HOW TO SETUP
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
A
Storage
Band
Pull Adjustment
Strap to remove
slack
Lift Grey
Recline Latch
Lift Grey
Recline Latch
B
Press Blue
Release Latch
13