Set Up; General Information; Convert To Rearward Facing - Britax Safe-N-Sound BS3700A-C20133 Series Instruction Manual

SETUP - GENERAL INFORMATION
FOR REARWARD FACING
CHILD SEAT UPPER ANCHORAGE POINT
This child seat must be installed using the top tether. The top tether will need to attach to the
appropriate upper anchorage point for both rearward and forward facing modes. Refer to the
car owner's handbook for anchorage locations or points. If your vehicle does not have an
upper anchorage point then you will need to install an upper anchorage point. Refer to pages
69 to 73.
REARWARD FACING
MEASUREMENTS
628mm
728mm
538mm
FORWARD
FACING
MEASUREMENTS
Width 467mm
Do not allow the front seat to alter
the installed angle of the restraint.
20
Instructions for Installation & Use
IS THERE ENOUGH ROOM ?
To ensure that the space is sufficient, the
purchaser should check the measurements
between the vehicle's rear and front seats in
which the child restraint is intended to be used
for both rear facing mode and forward facing
mode.
DO NOT USE RESTRAINT IN REARWARD
FACING MODE WITHOUT THE REBOUND
BAR FULLY EXTENDED.
Do not use the restraint without the top
tether strap correctly attached.
DO NOT USE A REAR FACING CHILD
RESTRAINT WHERE AN AIRBAG IS FITTED
IN FRONT OF THE SEATING POSITION.
Do not use on any vehicle seat which faces
sideways or rearwards.
SETUP - CONVERT TO REARWARD FACING
1
2
3
3
2

CONVERT TO REARWARD FACING

MODE:
To fully recline the child seat,
Step 1. Squeeze the grey recline lever
upwards.
Step 2. Press the blue release button down
whilst squeezing the grey recline lever,
rotate the child seat to rearward facing
position.
Step 3. Align arrow to rearward facing image.
HOW TO SETUP THE REBOUND BAR:
Step 1. Lift front flap in cover to access the
rebound bar.
Step 2. Pull out to full extension.
Step 3. Lift up to lock into position.
Instructions for Installation & Use
21