How To Set Up - Britax safe-n-sound BS7300N-020133 Series Instructions For Installation & Use

HOW TO INSTALL
ANGULAR ADJUSTMENT OF RESTRAINT
Some vehicle seats have more rearward slope than others. If the angle of the seat causes the baby to
be too upright for comfort, the angle may be altered by placing a firm packing between the seat and the
underside of the base. Packing can be a firmly rolled up towel.
If the car's seat is flat then some packing may be required at the front edge of the base to achieve the
recline angle.
Do not remove all of the rearward slope by over packing. Always leave a rearward slope angle of
approximately 10 to 15 degrees as shown
10° to 15°
28
Instructions for Installation & Use - Series No. BS7300N-020133
The stabilising bar does not
need to contact the back of the
car's seat, provided the seatbelt
is tight. If desired this gap may
be packed.
ADJUSTING HARNESS STRAP HEIGHT: FOR BABY USE REARWARD-
FACING
Correct fitment of the harness is very important as it restrains the child in the restraint. The harness must fit
firmly around the upper torso of the child and be positioned so as to leave the child's arms and legs free.
In rearward facing mode, the shoulder straps must be in the slots which are nearest to the child's
shoulders, but not lower than the child's shoulders. If your baby's shoulders have reached the lower
shoulder height marker then the restraint should be converted for "child use"(Refer to Forward-facing
section page 41).
The harness adjuster is fitted in different styles on different models. There is a push button adjuster that
must be pressed to loosen the harness and there is a lever operated adjuster that is fitted under a flap.
Check your child restraint to see which version you have.
Lower shoulder height marker
Harness tongues
Buckle
Instructions for Installation & Use - Series No. BS7300N-020133
HOW TO SETUP
Shoulder Harness
slots
Shoulder harness
straps
Harness Adjustment
Button or Harness
Adjustment Lever under
flap
Harness adjuster strap
29