Table of Contents
Advertisement
HOW TO USE
TO REMOVE CHILD
Press red button on harness buckle then both harness tongues will be released. Lift the shoulder straps
from the child's shoulders.
TO REMOVE RESTRAINT FROM VEHICLE
TOP TETHER
Release the stored strap and fully press top tether strap
adjuster button (1) while pulling the top tether strap (2)
to slacken as shown right. In some vehicles loosening
of the top tether strap may be difficult. If so, try pushing
the restraint against the vehicle seat back or slightly
lifting the restraint to release the tension.
Disengage attachment clip from the car's upper
anchorage point.
ISOFIT
Release the ISOFIT connector, squeeze the green
locking button and the red release button together, first
on one side, then on the other. The connectors are
disengaged. Replace the Lower Connector Protection
Moulding and store the insertion guides for future use.
SEATBELT
Unlock the upper lock-off (if fitted). Disengage the seatbelt
tongue from the buckle and remove from the restraint. Pull
the sash belt downwards to remove if from the upper lock-off.
30
Instructions for Installation & Use - Series No. 6100/A/2013
Fully press Adjuster Button (1)
while pulling Top tether strap (2) to
lengthen.
1
2
2
1
3
Upper
lock-off
REGULAR CARE OF THIS RESTRAINT:
Please check the following items regularly to ensure the safety of your child:
A. Check the webbing straps for fraying,
B. Check there are no cracks in moulding,
C. Check the harness adjuster is operating and is clamping the webbing,
D. Ensure the buckle is free of fluff, liquid or other matter that may enter the buckle slots. Clean the buckle
if it is sluggish to engage. See next page.
E. If any part of the restraint is cracked, broken or not operating seek repair immediately - contact
Customer Service 1300 303 330
CLEANING CHILD RESTRAINT
Use only mild soap and water to clean all metal and plastic parts of the restraint. Do not use chemicals or
cleaning agents.
HARDWARE: Use only mild soap and water to clean all webbing, metal and plastic parts of your child's
restraint, using a damp cloth.
Do not use chemicals or cleaning agents. Do not try and place any hardware into a washing machine.
STRAPS/HARNESS: We would only recommend that you spot clean the straps/ Harness with a damp
sponge. The harness straps can be soaked, however they must be thoroughly dried without excessive
heat (never tumble dry). The harness straps should not be placed in a washing machine as this may cause
damage to the stitching or even damage your washing machine.
CHILD RESTRAINT COVER: The restraint has a flame retardant cover which is removable for cleaning,
please clip the hook and loop together on the cover and seat pad (if supplied) to prevent any damage
to the cover when washing. Cleaning instructions are on the care label attached to the cover. All covers
are machine washable (gentle cycle), cold water only, rinse well and dry on a flat surface. Do not tumble
dry, bleach or dry-clean. Follow the care label on the cover.
Instructions for Installation & Use - Series No. 6100/A/2013
CARE & MAINTENANCE
31
Advertisement
Table of Contents
