Connecting The Lan Ethernet Cable - Avaya 1230 User Manual

Using your Avaya 1230 IP Deskphone
To use local AC power, use only the Avaya-approved Global Power
Supply (NTYS17xxE6) and country-specific IEC cable. You can order the
Avaya-approved AC adapter and country-specific IEC cable separately.
To use PoE, where power is delivered over the CAT5 cable, your
connected LAN must support PoE. If you use PoE, you do not require an
AC adapter.
1. Connect the DC barrel connector to the power jack on the back of the
IP Deskphone.
2. Thread the cable through the channel in the foot stand (if installed) to
secure the cable.
3. Plug the country-specific IEC cable into the Global Power Supply,
and then plug the Global Power Supply into the nearest AC power
outlet.

Connecting the LAN Ethernet cable

Connect your IP Deskphone to your LAN using a CAT5e Ethernet cable
to enable full functionality of your IP Deskphone. If your Ethernet port is
equipped with Power over Ethernet (PoE), your
Avaya 1230 IP Deskphone can be powered through the LAN port. Do not
extend the LAN Ethernet cable outside the building.
1. Plug one end of the supplied LAN Ethernet cable into the LAN
Ethernet port on the back of your IP Deskphone as shown in
on page 47.
2. Thread the cable through the channel in the foot stand (if installed).
3. Connect the other end of the cable to your LAN Ethernet connection.
The LAN LED on the back of the IP Deskphone lights when a LAN
connection is established.
49
CAUTION
Use only the approved Avaya Global
Power Supply with your 1230 IP
Deskphone.
Figure 8