Adjusting The Width Of The Backrest - Invacare TDX SP2 Series User Manual

1. Loosen the backrest plate screws A and B.
Do not remove the screws!
2. Move the backrest plate to the required height.
3. Re-tighten the screws.
5.6.2 Adjusting the width of the backrest (Modulite
seat unit)
You can adjust the backrest plate width to a certain degree by
adjusting the front plate, e.g. in order to adjust the backrest plate in
line with the seat cushion. Fairly large adjustments must be made by
a service technician to the rear plate and are outlined in the service
instructions for this mobility device.
1578997-C
Adjusting the mobility device to the user's seating posture
The sling back is only available in two widths of 38-43 cm and
48-53 cm and, under certain circumstances, must be replaced
for a width adjustment. For a replacement description, see
the service instructions for this mobility device. The service
instructions can be ordered from Invacare. However, they
contain instructions for specially trained service technicians
and describe operations that are not intended for the end
user.
Note that if the sling back width is adjusted the backrest
cushion must also be replaced.
Tools:
•
5 mm Allen key
Loosen and remove the backrest plate screw A.
1.
Loosen the backrest plate screws B.
2.
Do not remove the screws!
3. Move the backrest plate halves to the required width.
4. Re-insert screw A.
5. Re-tighten the screws.
41