Adding Rear Weight - Toro 04530 Operator's Manual

1
2
Figure 14
1. Suspension-arm bar
10. Close the latches down and around the cutting-unit bar
and lock them in place (Figure 13).
Note: A "click" can be heard and felt when the latches
are properly locked in place.
11. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 15).
12. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
of the motor (Figure 15).
g01461 1
2. Cutting-unit bar
1. Reel motor
2. Spline shaft
13. Mount a grass basket onto the basket hooks on the
suspension arm.
14. Repeat this procedure for the other cutting units.
15. Connect the cutting unit power disconnect couplers;
refer to Cutting Unit Power Disconnect (page 25).
8

Adding Rear Weight

Parts needed for this procedure:
1 Weight kit, 119-7129 (for 2-wheel drive units)
Weight kit, 120-5750 (for units with the 3-wheel drive
1
kit installed)
Procedure
This unit complies with the ANSI B71.4-2004 and EN 836
Standards when equipped with weight kit 119-7129 (2-wheel
drive units) or 120-5750 (3-wheel drive units).
17
Figure 15
3. Cavity
4. Motor retaining bar