Storage - Toro 04530 Operator's Manual

engine. After completing adjustments, repeat steps 4
through 9.
12. Repeat the procedure for all cutting units you want to
backlap.
13. When finished, return the Backlap Switch to the
Forward (F) position, replace the cover, and wash all
the lapping compound off of the cutting units. Adjust
the cutting unit reel to bedknife as needed. Move the
cutting unit reel speed control to the desired mowing
position.
Important: If the backlap switch is not returned
to the Forward (F) position after backlapping, the
cutting units will not raise or function properly.

Storage

If you wish to store the machine for a long period of time, the
following steps should be performed prior to storage:
1. Remove accumulations of dirt and old grass clippings.
Sharpen the reels and bedknives, if necessary; refer
to the Cutting Unit Operator's Manual. Use a rust
preventive on bedknives and reel blades. Grease and
oil all lubrication points; refer to Lubrication (page 36).
2. Block up the wheels to remove any weight on the tires.
3. Drain and replace the hydraulic fluid and filter and
inspect the hydraulic lines and fittings. Replace, if
necessary; refer to Changing the Hydraulic Oil and
Filter (page 41) and Checking the Hydraulic Lines and
Hoses (page 42).
4. All fuel should be removed from the fuel tank. Run the
engine until it stops from lack of fuel. Replace the fuel
filter; refer to Replacing the Fuel Filter (page 38).
5. While the engine is still warm, drain the oil from the
crankcase. Refill it with fresh oil; refer to Changing the
Engine Oil and Filter (page 37).
6. Remove the spark plugs, pour one ounce of SAE 30 oil
into the cylinders, and crank slowly to distribute the oil.
Replace the spark plugs; refer to Replacing the Spark
Plugs (page 37).
7. Clean dirt and chaff from the cylinder, cylinder head
fins, and blower housing.
8. Remove the battery and charge it fully. Either store
it on the shelf or on the machine. Leave the cables
disconnected if it is stored on the machine. Store
the battery in a cool atmosphere to avoid quick
deterioration of the charge in the battery.
9. If possible, store the machine in a warm, dry location.
43