Installing And Removing The Cutting Units - Toro 04530 Operator's Manual

lever to mow or transport and try to start the engine.
The engine should not crank, which means that the
interlock system is operating correctly. Correct the
problem if it is not operating properly.
3. Sit on the seat, move the traction pedal to Neutral,
move the functional control lever to Neutral, and
engage the parking brake. Start the engine and move
the functional control lever to mow or transport. The
engine should kill, which means that the interlock
system is operating correctly. Correct the problem if it
is not operating properly.
4. Sit on the seat, move the traction pedal to Neutral,
move the functional control lever to Neutral, and
engage the parking brake. Start the engine. Release
the parking brake, move the functional control lever
to mow, and rise from the seat. The engine should
kill, which means that the interlock system is operating
correctly. Correct the problem if it is not operating
properly.
5. Sit on the seat, move the traction pedal to Neutral,
move the functional control lever to Neutral, and
engage the parking brake. Start the engine. Move the
raise/lower mow control forward to lower the cutting
units. The cutting units should not start rotating. If
they do, the interlock system is not operating correctly.
Correct the problem.
Installing and Removing the
Cutting Units
Installing the Cutting Units
1. Disconnect the cutting unit power disconnect couplers;
refer to Cutting Unit Power Disconnect (page 25).
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the cutting unit power
disconnect couplers before working on the
cutting units.
2. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position (Figure 32).
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
1. Footrest—closed
3. Position the cutting unit under the center suspension
arm.
4. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure 33), push the suspension arm
down so that the bar fits over the bar across the top of
the cutting unit (Figure 34).
1. Latch—closed position
2. Suspension-arm bar
1
2
1. Suspension-arm bar
5. Close the latches down and around the cutting-unit bar
and lock them in place (Figure 33).
30
2
Figure 32
2. Footrest—open
1
2
Figure 33
3. Latch—open position
Figure 34
2. Cutting-unit bar
g014602
3
g014609
g01461 1