Servicing The Fuses; Drive System Maintenance; Adjusting The Transmission For Neutral - Toro 04530 Operator's Manual

WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.

Servicing the Fuses

The fuses in the machine's electrical system are located under
the seat (Figure 46).
1
Figure 46
1. Fuses
Fuse Layout
Hydraulic
Fan Kit
15 A
Lights
Leak Detector
15 A
Run
10 A
G017944
Lift Reel
E-Reel Enable
7.5 A
Reel Engage
Lift/Lower
7.5 A
Start/Run
Diag. Lights
Leak Detector
7.5 A
ECM Logic
Power
2 A
39
Drive System
Maintenance
Adjusting the Transmission
for Neutral
If the machine creeps when the traction control pedal is in
the neutral position, the neutral return mechanism must be
adjusted.
1. Block up under the frame so that one of the front
wheels is off of the floor.
Note: Note: If machine is equipped with a 3 wheel
drive kit, also raise and block rear wheel.
2. Start the engine, move the throttle to Slow, and check
the front wheel that is off of the floor; it must not be
rotating.
3. If the wheel is rotating, stop the engine and proceed
as follows:
A. Loosen the nut securing the eccentric to the top
of the hydrostat (Figure 47).
1
Figure 47
1. Eccentric
B. Move the functional control lever to Neutral and
the throttle to Slow. Start the engine.
C. Rotate the eccentric until creep does not occur in
either direction. When the wheel stops rotating,
tighten the nut locking the eccentric and the
adjustment (Figure 47). Verify the adjustment
with the throttle in the Slow and Fast position.
Note: If the wheel still turns when the eccentric
is at the maximum adjustment, contact your
Authorized Service Distributor or refer to the
Service Manual for further adjustment.
2
g014616
2. Locknut