Installing The Steering Wheel; Activating And Charging The Battery - Toro 04530 Operator's Manual

4. Locate the open connector on the main wiring harness
to the right of the seat and connect it to the wiring
harness that came with the seat.
5. Route the seat wiring harness around the seat slides,
ensuring that it will not be pinched when the seat
moves, and connect it to the port on the bottom of
the seat.
3

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
1 Locknut (1-1/2 inches)
1 Washer
1 Steering wheel cap
Procedure
1. Slide the steering wheel onto the steering shaft (Figure
5).
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft (Figure 5).
3. Secure the steering wheel to the shaft with a jam nut
and tighten it to 27 to 35 N-m (20 to 26 ft-lb) (Figure 5).
4. Install the cap to the steering wheel and secure it with a
screw (Figure 5).
Figure 5
3. Jam nut
4. Cap
4
Activating and Charging the
Battery
No Parts Required
Procedure
Use only electrolyte (1.265 specific gravity) to fill battery
initially.
1. Remove the fasteners and battery clamp and lift out
the battery.
Important: Do not add electrolyte while the
battery is in the machine. You could spill it,
causing corrosion.
2. Clean the top of the battery and remove the vent caps
(Figure 6).
3. Carefully fill each cell with electrolyte until the plates
are covered with about 6 mm (1/4 inch) of fluid (Figure
7).
1. Electrolyte
13
Figure 6
Figure 7